Gfp 865DH
February 2018
21
19B. Thermal film
1.
Place thermal film roll on top and bottom supply shafts
2.
Pull the top film over the top idler roller and drape down across the front Nip
roller.
3.
Turn the front hand-wheel counter clockwise to raise the front Nip roller
4.
Turn the rear hand-wheel to raise the rear pull.
5.
Raise the feed tray assembly
6.
Pull the bottom film behind the bottom idler roller and up over the two nip rollers
7.
Using a threading board, pass the two film webs through the Nip rollers,
8.
Lower the top nip roller by turning the front hand wheel clockwise until the two
rollers touch
9.
Use foot pedal to advance the film web into the Pull rollers then lower the rear
puller roller by turning the rear hand wheel clockwise until the rollers touch
10.
Lower the feed tray assembly
11.
Use foot pedal to advance both webs until cleared of the pull rollers
12.
Adjust the roller pressure on both sets of rollers to the desired position
Warning Ensure the
safety shield is in place before operating
the Laminator. Operating without the safety shield can cause
serious injury
1. Top Nip roller
2. Linkage shaft for roller adjustment
3. Top idler roller
4. Top film web
5. Top film supply roll
6. Top Rear Pull roller
7. Bottom Rear Pull roller
8. Bottom film supply roll
9.
Bottom
film web
10. Bottom idler roller
11. Bottom Nip roller
