GEZE UFO-NT F, Wiring Diargam

Page: 67 / 80

UFO-NT
67
Service menu
27.3.11 Default setting
Name 1 Sub-menu 2 Sub-menu Explanation
Default setting no
Reset all the values to the de-
fault settings.
The state is the same as the
state after the default setting.
Values to standard setting, fault
memory, position and opening
angle are deleted. A teaching run
and initialisation run are necessary.
yes
27.3.12 Delete maintenance
Name 1 Sub-menu 2 Sub-menu Explanation
Delete maintenance no
Clear the maintenance values.
yes
27.3.13 Password
Name 1 Sub-menu 2 Sub-menu Explanation
Change PW S1 Password old 0000
Password new
----
for access to the service menu
with ST220.
DPS disabling Password old 00
Password new
--
Is used to enable the DPS
instead of enabling via a key
switch. Disabling reoccurs auto-
matically after 1 minute without
key actuation.
The first digit specifies how
often the key

has to be
activated and the second digit
how often the key  has to be
activated to release operation of
the DPS.
Block parameters no
yes
Entering the password in control unit ST220
X
Change digit with  or  .
X
Confirm digit and change to next position with

.
X
Abort with x .
Display of the current position by the asterisk under it.
X
After completing entry, press

to accept the password.
à
After 1 minute without a button being pressed or when the service menu is accessed again, the password is re-
quired before changes to the operating mode setting or to the parameter settings can be carried out.
à
The password has to be set separately for the active leaf and passive leaf drive. The active leaf drive and the passive
leaf drive can have different passwords.
à
When the password for ST220 is set, access to the service menu via DPS is no longer possible.
à
If the password has been forgotten, a special flash file with which the password on the control can be reset to 00
has to be requested from GEZE.
à
The password cannot be deleted by installing a new software version