The power button ❶
blink red light, and
single cup button ❷
and double cup button
❸ blink blue light.
The pressure gauge
❻ pointer reaches
the red zone.
The temperature inside
the machine is too high,
because making coffee
immediately after ma-
king steam.
1. The coffee powder
is too fine which makes
the temperature of the
brewed coffee is higher
than normal.
2.Natural cooling：Do
nothing and let the
machine stand still
and wait for about
half an hour.
Do not use coffee
powder that is too
fine.
2.The outlet of the
filter/portafilter ❿ is
blocked.
3. The water outlet of
the filter holder ❾ in
the coffee maker is
blocked with coffee
powder.
Remove and clean the
filter and clean the
two outlet holes under
the portafilter ❿.
Clean the coffee pow-
der attached to the
machine's water outlet
of filter holder ❾ with
rag.
Solution
Problem
Picture
Possible Cause
1.Manual cooling：
Turn the steam/water
knob ⓮ to the “ ”
to reduce the pressure,
and hot water will flow
out. When the tempe-
rature becomes down,
the water pump will
stop automatically
after 20 seconds. After
the pressure is reduced,
turn the steam/water
knob ⓮to the horizontal
position (off-position)
and then begin to brew
coffee.
36
35
/
The power button ❶
keep blue light fixed,
the other button’s
light ( single cup bu-
tton ❷, double cup
button ❸ and steam
button ❹)blink blue
and beep at the same
time.
Coffee leaks out
from outer side of
portafilter ❿.
The machine is on
while the steam/water
knob ⓮ is not fixed
in the off position.
1.There is some coffee
powder on the edge of
portafilter ❿.
2. The portafilter ❿ is
not installed properly.
3. The coffee powder
is too fine.
4. The coffee powder
on the portafilter ❿
is pressed too tightly.
Reset steam / water
knob ⓮ to horizontal
position (off-position).
Clean coffee powder
on the edge of the
portafilter ❿.
Re-install the porta-
filter ❿ correctly.
Do not use coffee po-
wder that is too fine.
Press the coffee pow-
der lightly to the max
line.
5. The two outlet holes
of the portafilter ❿ is
blocked.
6. The holes of the
filter is blocked.
Remove the filter and
clean the two outlet
holes under the
portafilter ❿.
Soak the filter in clean
water for about half an
hour, then clean it with
a brush.
