5
If the equipment is used in contaminated areas
there is a risk of severe injuries or death caused
by harmful substances in or on the equipment.
Before working on the equipment make sure
that it is completely decontaminated. Always
wear the protective clothing prescribed for
contaminated areas when working on the
equipment.
The equipment must only be used with fluids
that do not attack the material and the gaskets
and sealings of the equipment. Otherwise leaks
may occur and hot or toxic fluid could escape.
The equipment and its component parts must
only be mounted or removed by qualified
personnel. A qualified person must be
acquainted with and experienced in the
following:
Making pipe connections.
Selecting suitable lifting gear and
understanding the rules for its safe use.
Working with dangerous (contaminated, hot
or pressurized) fluids.
If unsuitable lifting gear is used or the gear is
used improperly the equipment or parts of it
could fall down.
Make sure that only qualified personnel lifts
the equipment or parts of it.
Make sure that nobody is standing or
working below the hoisted equipment.
Make sure that the lifting gear is of sufficient
strength for the load to be hoisted and that
the load is properly secured and attached to
it. For more information on the nature and
weight of the components and safe lifting
points please contact the manufacturer.
Make sure that all locally applicable
regulations on safety and the prevention of
accidents are strictly adhered to.
If the admissible temperature and pressure
limits are exceeded the equipment may be
destroyed and hot or pressurized fluid may
escape. Make sure that the equipment is only
operated within the admissible service range
and limits.
For more information on limits and pressure &
temperature ratings see name plate and the
section "
Technical Data
".
The equipment may be damaged if the
connection of the equipment with the pipe is not
stable enough or the equipment is not
sufficiently supported. Hot or pressurized fluid
may escape. Only qualified personnel is allowed
to install and connect the equipment.
If the support of the equipment during
installation is insufficient the equipment might
fall down, thereby causing bruises or injuries.
Make sure the equipment is safely held in place
during installation and cannot fall down. Wear
the protective clothing specified for the place of
installation.
If the stuffing box is leaking there is a risk of
severe injuries caused by escaping hot fluid.
Use the equipment only if it is in proper working
condition. Replace any leaking stuffing box seal.
The equipment can be provided with different
types of actuator, e. g. with an electric or
pneumatic actuator. Depending on the type of
power supply for the actuator there is a risk of
severe injuries or death for various reasons.
Before working on the equipment cut off power
supply to the actuator. Observe all danger notes
and follow all instructions given in the
installation & operating manual of the actuator.
If you have a question please contact the
manufacturer of the actuator.
The moving parts of the equipment can cause
severe injuries or death. Make sure that nobody
is standing close to these moving parts or can
touch them while the equipment is operating.
Before working on the equipment make sure
that the power supply to the actuator is cut off
and cannot be switched on accidentally.
Summary of Contents for ZK 29
Page 1: ...Control Valve ZK 29 Original Installation Instructions 810685 05 ...
Page 58: ...58 ...
Page 59: ...59 ...
