20
Basic settings
Factory setting
The level electrode features the following factory set default values:
Baud rate:
250 kB/s
Attenuation of the measuring signal: 19 sec.
Node ID:
041
Attention
We recommend that you commission the CAN bus devices with the default factory
setting.
Do not use a node ID for more than one piece of equipment in the CAN bus system.
Establishing / changing node ID
If several identical systems are to communicate in a CAN bus network, set a different node ID for each
system (e. g. limiter, controller, etc).
1. Undo screws
=
and remove housing cover
a
.
2. Change switch positions of code switch
c
as required.
Please observe the wiring diagram on page 19.
3. Put housing cover
a
in place and fix it with screws
=
.
- continued -
