GESTRA BB 1, Original Installation Instructions

Page: 26 / 52

26
To mount the plates in large equipment use suitable
lifting gear. Attach the lifting gear to the plates as
follows:
 Insert two eye bolts in the bores for the
threaded bolts (11) in the plate supports.
 Attach lifting gear of sufficient load bearing
capacity to the eye bolts.
DANGER
Risk of bruises if the equipment or
component parts fall down.
 Use suitable lifting gear when moving
or lifting the equipment and/or
component parts.
 Make sure that the equipment cannot
topple over.
 Make sure that nobody is standing
below the lifted equipment.
 Lift off the plates at the plate supports.

Put the plates as shown into the body.
 Make sure that the plates fully rest against the
body seat

Remove the eye bolts and keep them for future
use.

Turn the plates until the bores in the plate
supports are underneath the stops (1.).

Insert the two threaded bolts (11) (2.).
The required torque for tightening the threaded
bolts (11) depends on the material of the threaded
bolt and the body as well as the nominal size. For
information on the required tightening torques see
the following table.

Fasten the threaded bolts with the specified
tightening torque.