5
2. Take one of the stand back panels and hold it vertically as shown in figure 3i. Carefully insert the
stand back panel into the cut-out in the rear of the stand base, ensuring that the two locating dowels in
the base (A, figure 2) fit into the matching holes in the stand back (A, Figure 3i).
3. Insert a M8 x 50mm socket head screw into each of the three recessed holes on the bottom edge of
the stand back panel (B, figure 3ii). Using the appropriate hex key, tighten these screws until the two
parts are pulled together and then tighten one further
half turn
.
4. Fit a M5 x 16mm socket head screw into hole C on the stand back panel, Fig 3i and screw it all the
way in by hand. Tighten one further
quarter turn
using the appropriate hex key. This is the loudspeaker
suspension screw.
5. Pick up a PQS-100 Plus by the upper plate and holding it with the rear face away from you, fit the key-
hole plate in the rear face of the loudspeaker figure 4, over the loudspeaker suspension screw you have
just fitted – C, figure 3i.
Figure 3. PQS-Plus Stand Back Panel
i
A
C
ii
B
D
D
E
E
Key-hole Plate
Figure 4. PQS-100 Plus Rear Face
