Gerber HS750 Plus, User Manual

Page: 48 / 94

42 HS750
plus
RUN SINGLE
Use
RUN SINGLE
to plot a single job. This plot mode allows the
operator to reposition material between jobs and/or to pen plot
using paper before cutting vinyl.
RUN SINGLE
may be used with
either swivel knife mode or tangential knife mode.
Plot
1. Press
SWIVEL KNIFE
to select a knife mode. (For swivel knife
mode, the light over the
SWIVEL KNIFE
key is on. For tangential
knife mode, the light is off.)
2. Press
RUN SINGLE
. The light over the
RUN SINGLE
key comes
on and the HS750
plus
plots a single job. If other plot files are
received from the
GRAPHIX ADVANTAGE
while the first job
plots, then a waiting list (called queue) of these jobs is created
in the
GRAPHIX ADVANTAGE
.
The HS750
plus
returns to the off-line status after the job plots. It
remains in the knife mode selected.
The HS750
plus
waits for the operator to press the
RUN SINGLE
key
again to plot the next job. If other jobs are lined up in the queue,
the green lights above the two Run keys will flash.
Controlled Stop
Use
RUN SINGLE
(or
RUN CONT
) to pause plotting and check the
current job.
1. During a job, press the Run key which is currently selected
(lit). The HS750
plus
stops the plot at the next logical break in
the program.
Note: The slew keys may be pressed to maneuver the
carriage or material. However, when the Run key is pressed
again to exit the pause mode, the plotter will return the
carriage and material to the point where the job was paused.
2. Press the same Run key to resume plotting at the exact same
point.
RUN
SINGLE