Operating instructions Starterset Z LED 60 Set
Status 19.01.2021
(TNR: 33700066 / 33700067)
GERA Leuchten GmbH
3.
Teach the control unit to the radio remote control
You can teach in an infinite number of control units per zone button .
We recommend first teaching in all control units to zone key 1.
Then the control units can be taught-in again individually for the remaining zones, as explained
under point 4.
3.1 VARIANT 1
–
teach-in button on the control unit
(1)
Carry out a RESET.
Press the teach-in button for longer than 3 seconds or until the connected light source
flashes briefly to indicate that the reset was successful.
(2)
You can then prepare the control unit for teaching by briefly pressing the teach-in button .
(3)
Immediately afterwards, press one of the six zone buttons for approx. 3 seconds.
(4)
Check FUNCTION. Long press on the zone button of the radio remote control to switch
the respective zone on / off.
Repeat the process to teach in additional devices
.
3.2
VARIANT 2
–
Voltage interruption to the control unit
If the control unit is inaccessible, do the following:
(1)
The voltage supply to the control unit must be briefly interrupted in order to signal to the
control unit that a learning process is taking place. The interruption can be done by pulling
the power plug or by a switch (house installation).
(2)
Then restore the voltage (plug in the mains plug or switch on the switch).
Immediately afterwards, press one of the six zone buttons twice quickly (like a double-
click) and then once long for approx. 3 seconds. This sequence must take place immediately
one after the other.
(3)
Check FUNCTION. Long press on the zone button of the radio remote control to switch
the respective zone on / off.
Repeat the process to teach in additional devices.
IMPORTANT! After each teach-in process, you should wait 60 seconds before teaching in further devices.
If there is no connection between the radio remote control and the control unit, repeat steps 3.2.1 - 3.2.2
You can repeat this step as often as you like.
If there is no connection between the radio remote control and the control unit, repeat steps 3.1.1 - 3.1.3
You can repeat this step as often as you like.
IMPORTANT! The learning process is limited in time. The teach-in process must be restarted after 5 seconds.
IMPORTANT! The learning process is limited in time. The teach-in process must be restarted after 5 seconds.
