Gun Not Spraying?
It could be that the two holes inside the lid have become blocked. To unblock
unscrew paint container from the gun. Pull out paint Pick Up Stem from the
Gun Body. On either side of this hole there are two smaller holes (refer to
Figure 2). One or both of these holes may be blocked with dry paint.
To clean, use a long piece of timber dowel or wire (a straightened wire coat
hanger is ideal) to unblock the dry paint by prodding holes till paint loosens.
Be careful not to damage or enlarge these holes.
This procedure should be carried out every time especially if using fast
drying paints.
For further information please contact the GEPRO Customer Service
Centre on 1800 350 001
WARNING
Read and observe the following safety instructions before using this product to avoid
personal injury. It is important to read the instructions manual to understand the
applications, limitations and potential hazzards associated with the paint outfit.
ADDITIONAL SAFETY INSTRUCTIONS
1. Ensure the power source conforms to requirements on the name plate of the blower unit
2. Always wear safety equipment such as goggles, ear protection, respirator, gloves and
protective clothing and footwear while operating this unit.
3. If using and extention cord, check it for any damage before using.
4. Before connecting the blower to mains power make sure the machine is in the OFF position
5. Only use this machine in a well ventilated area.
6. Never immerse the blower unit in water.
7. Never point the spray at people or animals.
8. Always turn the unit off when refilling or removing the spray gun.
9. Never leave the unit on and unsupervised.
10. Do not allow children to operate this unit.
11. Spraying solvents - refer to warning on page three (3) of manual.
12. Only use this machine for the use it is intended.
13. Never spray paint onto or into the air take of the blower unit.
14. Never cover the air intake vents.
15. Never leave paint in the spray gun when storing.
IMPORTANT NOTICE
