Geostar Aston Compact Series, Installation Manual

Page: 28 / 56

28
ASTON COMPACT INSTALLATION MANUAL
Wiring Schematics cont.
FX10 Control 460/60/3 5-Speed ECM
Relay coil
Capacitor w/ bleed resistor
Switch - Condensate overflow
Switch - High pressure
Switch - Low pressure
Polarized connector
Factory Low voltage wiring
Factory Line voltage wiring
Field low voltage wiring
Field line voltage wiring
Optional block
DC Voltage PCB traces
Internal junction
Quick connect terminal
Field wire lug
Ground
Relay Contacts-
N.O., N.C.
1 3 2
P
L1
Field Zone Sensor Wiring
Open Jumper
Closed Jumper
Legend
RCP
Rectified Compressor
Solenoid Plug
Compressor Solenoid
CO -
FD -
DA -
DF/BP
CP -
OS -
ES -
HP -
LP -
PB1, PB2 -
DH -
RV -
Condensate Overflow Sensor
Freeze Detection Sensor
Discharge Air Temperature Sensor
Dirty Filter or Blower Proving
Emergency Shutdown
High Pressure Switch
Low Pressure Switch
Power blocks
Dehumidification Switch or Humidistat
Reversing Valve coil
Compressor Proving
Occupied Switch
TB - Terminal Board
CC - Compressor Contactor
CS - Compressor Solenoid
RCP - Rectified Solenoid Compressor Plug
PR- Pump Relay
RB- Blower Relay
Notes:
1 – Disconnect for 15 degree freeze detection limit.
2 – Acc 1 output is cycled with the compressor.
3 – Acc 2 output is cycled with the blower.
4 – R, C, Y1, Y2, and G inputs are for use with a wall mount thermostat.
TO, SC, RS, AIC, and SS are for use with a TAXXJ02 zone sensor.
5 – Network controllable 24VAC output.
6 – Network controllable PWM output.
7 – Wire #52 can be used to connect a field supplied and installed 0-5 VDC
humidity transmitter.
8 – Not Used – Bundle in the air handler.
9 – Optional, factory installed unit mounted disconnect
10 – Optional, factory installed phase guard
11 – Optional, factory installed phase guard. The yellow transformer wire
shall be connected directly to the PB1-1, if this option is not installed.
12 – Optional, factory installed internal isolation valve.
14 – Network configurable input.
15 – Refer to the 5-Spd ECM Low Voltage Connection Table.
PGM - Phase Guard Module
RH - Reheat Valve Coil
97P822-05 3/19/12
PB2
3
2
1
T
CO
T
2 1 3
Isolation
Valve
6
1
12
5
13
2
9
10
4
14
7
15
3
11
24VAC (R)
24V COM (C)
Alarm (L)
Acc 1 (X1)
Acc 2 (X2)
Blower (G)
Rev Valve (O)
Comp (Y1)
Comp (Y2)
Setpoint Shift (SS)
AI COM (AIC)
Room Sensor (RS)
Sensor COM (SC)
Temp Occ (TO)
Alarm Circ A (LC1)
Alarm Circ B (LC2)
Terminal Board
TB
Green/Yellow (38)
Black (31)
Black (44)
Note 2
Note 3
Red
(87)
Green
(86)
White
(88)
Black (C)
Black (R)
Black (L)
Black (X1)
Black (X2)
Black (G)
Black (O)
Black (Y1)
Black (Y2)
Black (SS)
Black (AIC)
Black (RS)
Black (LC1)
Black (LC2)
Zone Sensor Terminal 1
Zone Sensor Terminal 3
Zone Sensor Terminal 2
Zone Sensor Terminal 5
Zone Sensor Terminal 6
Note 4
Red (33)
Black (34)
Brown (13)
Violet (15)
Yellow (18)
B
Black (5)
Yellow (50)
Brown (60)
Brown (61)
White (62)
White/Blue (42)
Black (63)
Black/Red (64)
Gray (65)
Orange/White (67)
Yellow (51)
Yellow/White (52)
Yellow/Red (53)
Orange (66)
Note 7
Gray (65)
Orange (66)
Orange/White (67)
Green (70)
Orange (71)
Blue (72)
Yellow (21)
Green (70)
Orange (71)
Blue (72)
Yellow (21)
Black/White (29)
Orange (30)
LP
ES
OS
Pink (25)
Blue (27)
Blue (32)
Red (24)
Violet (23)
Black (22)
DF/BP
Note 1
Blue (10)
CP
Note 6
Gray (68)
Note 12
DA
FD
Note 14
Gray (26)
Gray/White (14)
Tan
5-Spd ECM Low Voltage Connections Single Speed
Model TAP-1 TAP-2 TAP-3 TAP-4 TAP-5
015 Blue Red Gray
018 Blue Red Gray
024 Blue Red Gray
030 Blue Red Gray
036 Blue Red Gray
042 Blue Red Gray
048 Blue Red Gray
060 Blue Red Gray
070 Blue Red Gray
Motor Low Voltage Connections Dual Capacity
Model
TAP-1 TAP-2 TAP-3 TAP-4 TAP-5
026 Blue Red Tan Gray
038 Blue Red Tan Gray
049 Blue Red Tan Gray
064 Blue Red Tan Gray
072 Blue Red Tan Gray
WSHP Sensor
24VAC Power
Al Com
Room Sensor
Sensor Com
Temp Occ
R
AIC
RS
SC
TO
+
-
SEN
O/R
SET
Ɣ
Ɣ
Ɣ
Ɣ
Ɣ
TAXXA04 Room Command
Module with LCD