www.glorystar.tv
Toll Free 866-597-0728
CAUTION: DO NOT ATTEMPT TO OPERATE ELECTRONIC
DEVICES IN AN UNSAFE LOCATION OR IN VIOLATION
OF SAFEGUARDS PROVIDED IN THIS MANUAL OR ANY
OTHER EQUIPMENT MANUAL PROVIDED WITH THIS
SATELLITE SYSTEM.
Remove the satellite receiver and remote control from the packaging. Inspect the
unit before operation. If any equipment is damaged or if you have any questions,
please immediately contact your reseller. Install the two included AAA batteries
into the remote control battery compartment.
The
BEST and Easiest
method to aim the satellite dish is to temporarily place
the satellite receiver and a small TV near the satellite dish. This method allows
the installer to see the signal changes that occur with small dish movements. It is
extremely difficult to install the satellite system if the TV is inside the home and
out of the view of the installer. Attempting to communicate the signal readings
with a second person viewing the TV will complicate the aiming process!
Connect Receiver to a TV
To view high definition video in HD and listen to digital audio, connect a HDMI
cable between the receiver and TV. No other cables are needed with the HDMI
cable.
A basic connection for standard definition SD TV viewing is to connect the to the
TV with the included RCA cable. Connect the yellow Video port and the white/
red Audio RCA jacks from the receiver to the yellow/white/red RCA plugs on the
TV’s AV IN jacks.
Plug the television power plug into a surge protected AC power strip. Turn the
TV power ON and set the TV to the AV input. The TV is now ready to view the
satellite receiver.
Best Quality Picture
Poor Quality Picture
