Glorystar - Local Time is set by
selecting your Time Zone. With Time
Zone highlighted, press the
Left or
Right Navigation
key to display the
install location time zone. For Example:
-5:00 EST - New York is the correct
time zone selection for the east coast of
the US.
5.
Press the
Down Navigation
key
to highlight “Does this Time Zone
observe Daylight Savings?” Press the
Right or Left Navigation
key to select
OFF if your location does not change
between Standard and Daylight Savings
or ON if your location changes between
Standard and Daylight Savings.
6.
Press
OK
key to continue. Please take a few minutes to read this Glorystar
Install Guide. When you are ready to continue the install, press the
OK
key to
continue.
7.
A
Signal Strength
reading of 0-5% indicates that the receiver is not properly
connected to a working LNBF. The low
Signal Quality
reading at or below 30%
indicates that the dish is not properly aimed or the LNBF is not properly rotated
to receive the satellite signal.
A
Signal Strength
reading of 50-80% indicates that the receiver is connected to a
working LNBF. No
Signal Quality
reading indicates that the dish is not aimed.
Signal Strength and Quality Meter
The
Signal Strength
and the
Signal Quality
meters provide important information
about the satellite system. Here are some examples of different meter reading and
what they tell you about the wiring connections, dish aiming and LNBF rotation.
It is very important to optimize the Signal Quality readings to provide the best
performance during adverse weather conditions. The higher the Signal Quality
reading, the better the reception. If the Signal Quality reading is too low, the
picture will break up into little squares and the sound may become garbled, out of
sync, choppy or disappear completely!
