SAFETY
WARNING! Ensure Health & Safety, local authority, general workshop
practice regulations are adhered to when using equipment.
WARNING! Installation site must be equipped with suitable fire
extinguishers (water must not be used) and escape routes.
WARNING! Disconnect the air supply from the tank before changing
accessories, servicing or performing any maintenance.
Maintain the tank in good condition (use an authorised service agent).
Replace or repair damaged parts. Use genuine parts only. Unauthorised parts
may be dangerous and will invalidate the warranty.
Locate the tank in a suitable work area. ensure the tank stands on a firm, level
surface. Keep area clean and tidy and free from unrelated materials. ensure the
area is well ventilated and has adequate lighting.
WARNING! Ensure specified air pressure is maintained and not exceeded.
Keep air hose away from heat, oil and sharp edges. Check air hose for wear
before each use, and ensure that all connections are secure.
WARNING! This tank is recommended for use only with degreasing
solvents suitable for air operated tanks. Ensure you follow makers
instructions for solvent use.
Ensure solvent flash point is above 140°F(60°C).
Keep the tank clean. Remove and clean the tank filters regularly for best
performance.
WARNING! DO NOT SMOKE and keep sources of ignition, such as heaters,
lamps, etc., away from the unit, together with flammable or combustible
materials, as there is an explosion risk.
When cleaning parts ensure that nothing in the tank, including any parts
basket, is in a position that would prevent the lid from closing fully if and
when the fusible link activates.
WARNING! DO NOT modify the lid or jam it open. Keep the lid and holding
screws in place, tight and in good working order.
WARNING! DO NOT attempt to perform welding on the unit for any reason.
DO NOT weld near the unit.
WARNING! Wear approved safety eye protection, mask and gloves. If
solvent gets on skin or in eyes wash thoroughly with water and take any
other action as required by the solvent instructions.
INTRODUCTION
3
Remove ill fitting clothing, ties, watches, rings and other loose jewellery, contain
long hair and wear appropriate protective clothing.
Maintain correct balance and footing. ensure the floor is not slippery and wear
non-slip shoes.
Keep non-essential persons away from the working area.
In case of fire in tank, do not attempt to move unit or remove parts from tank. The
lid is fusible and will automatically close extinguishing fire.
Disconnect the unit from the air supply when not in use.
DO NOT
use the tank for any purpose other than that for which it is designed.
DO NOT
operate the tank if any parts are missing or damaged as this may cause
failure and/or personal injury.
DO NOT
over-fill the tank.
DO NOT
modify or jam the parts washer lid open, as this will make the fusible fire
link inoperative which is dangerous practice and will invalidate the warranty and
your insurance.
DO NOT
use air line to blow dry components in tank. only use air gun supplied.
DO NOT
direct air gun at yourself or others.
DO NOT
leave the parts washer operating unattended.
When cleaning is complete, ensure all controls are in the ‘off’ position and that the
air supply is disconnected.
WARNING! It is owner’s responsibility to ensure that there is no
uncontrolled discharge of any fluids used with this unit and that appropriate
arrangements have been made for correct disposal of waste in accordance
with government/local authority regulations.
Steel fabricated 65ltr reservoir and 50ltr one-piece tank. Mobile unit with two castors
and two fixed wheels can be easily taken to work area. Air operated unit can be
charged and used remotely without air supply for a limited period. Includes air blow gun
for fast drying and brush for cleaning workpiece. Reservoir fitted with fluid level
indicator and drain tap. Supplied with removable shelf and tray. lid fitted with fusible link
hinge which automatically snaps shut in the event of a fire.
