As you unpack the
product, check contents.
Should there be any
damaged or missing
parts contact your
supplier immediately.
Assemble the gate
valve (A) which
connects the tank to the
reservoir, directly to the
reservoir as shown in
fig.1, ensuring that a
rubber seal is fitted to
both ends of the valve.
Screw the air regulator
and safety valve
assembly (B) to the
ASSEMBLY
AIR SUPPLY
5
4.6.
5.1.
5.2.
5.3.
5.4.
5.5.
5.6.
5.7.
reservoir as shown in fig.2 ensuring that the rubber seal provided is in place.
Assemble the two upper tank support arms (C) into the sockets provided on the
tank but do not tighten the fittings yet.
Place the upper tank onto the support arms and lower it down until the tank outlet
drops into the top of the gate valve (A). Fix the tank to the valve by tightening ring
(Q) as shown in fig.4. Tighten the hex socket bolts at either end of the upper tank
supports (C). Fit handle into support arm brackets (C) and tighten.
Mount the cleaning brush in its stowage position on the underside of the lid over
to the left hand side. Feed the brush tube (T) through the hole in the right-hand
side of the tank and connect it to outlet (R) on the head of the regulator /safety
valve assembly.
Ensure that the air regulator valve is closed before connecting the air supply.
An air pressure of 40-60psi and an available air volume of 6cfm will be required to
operate the unit.
WARNING! Ensure air supply is clean and does not exceed 110psi. Too high
an air pressure and/or unclean air will shorten the product life, and may be
dangerous, causing possible damage and/or personal injury. Air supply
must be equipped with regulator & water trap.
Drain the air supply tank daily. Water in the air line will damage the unit.
Clean the air supply filter weekly. For recommended hook-up, see diagram below.
Line pressure should be increased to compensate for unusually long air hoses
(over 8 metres). The minimum hose internal diameter should be 10mm and
fittings must have the same internal dimension.
Keep hose away from heat, oil and sharp edges. Check hoses for wear, and make
certain that all connections are secure.
The air inlet connection is 1/4”.
