TrueView 435 Hardware User Guide
32
TrueView 435 Hardware User Guide
10/26/2021
Figure 45
–
DJI Pilot, Flight Controller Settings Menu
5.
Controller Box LEDs
8.
When the power switch is turned on, the system will go through its startup procedure and all
lights (Figure 46) on the controller box will flash yellow. After a few seconds, each LED light will
begin to show a sequence of colors indicating status.
a.
BAT: Flashes until the battery percentage is known, then turns a solid color.
i.
Green LED indicates battery is above 50%.
ii.
Yellow LED indicates battery is between 30 and 50%.
iii.
Red LED indicates battery is below 30%.
b.
GNSS: This LED will flash yellow until GNSS signal is received, then turn solid green.
c.
SYS: The system light will flash yellow until the system is ready for operation. When the
system is ready, it will begin flashing green if proximity mode is active.
i.
Proximity mode is a feature added in firmware version 2.0.3. When the system
is powered on, its position is recorded, and this position is used as the home
point for the system. Once the sensor travels a specified distance (25 meters by
default) from the home point, the system automatically begins recording data.
This feature can be disable by setting the
“ProximityMode” flag to false in the
Core Configuration file on the UMS. If the feature is disabled, you will have to
manually start recording data by pressing and holding the green button until
the SYS light turns solid green.