6
Setting Platen Height
The height adjustment knob on the DK20SP allows for thicker
items to be placed in the press. The factory set height of the press is
the proper platen height setting for most fabrics, and materials under
1/4” thick. Unlike manual presses, the actual amount of pressure on
the DK20SP is determined by the air regulator and air gauge, NOT
by the height of the heat platen. However, if the platen height does
not provide enough clearance for especially thick items, this can be
adjusted.
•
To raise the heat platen, turn the
pressure knob to the left,
counterclockwise.
•
The top head will rise away
from the lower table.
•
To lower the heat platen, turn
the pressure knob to the right,
clockwise.
•
The top head will lower toward
the pressing table.
Actuating the Press
To actuate the machine,
simply press both black buttons
together. This will cause the air
bladder to fill, the table to raise,
and the work to be pressed. The
digital timer will automatically
begin cycling. At the end of the
timer cycle the press will
automatically release and the
timer will reset to the preset time. BOTH black buttons must be
pressed together, to insure that both operators hands are clear of the
pressing area, for safety purposes.
To interrupt the timing cycle, in order to do a quick pre-press or
press for a shorter period of time than is set, simply press both black
buttons together again. For emergency one-hand release of the air
pressure, press the middle button on the front panel.
