3
1. INSTALLATION OF OPTIMA 100 DESIGN
1.1 Installation of the Control Panel
The control panel is designed to be mounted onto
a level wall.
1.2 Installation
Find the installation place for the control panel, mark off
the holes and screw the fixture securely onto the wall.
Use at least 4 screws for securing the panel, two at the
top and two at the bottom.
Obligatory screw
Obligatory screw
Obligatory screw
Obligatory screw
Screw
Screw
Hold up the wall frame against the wall and mark off the
holes for fastening the frame. Drilling of holes, hole size
and suitable screws for fixing the panel all depend on the
wall material.
Place the control panel in the fixtures and tilt it in against
the wall. The four support points in the corners of the
display must touch the wall to keep the display stable.
A
Support
point
Support
point
Support
point
Support
point
Underneath the control panel there is access for the:
A: Terminal block. Connection to main circuit board
Fit a 8 x 0.25 mm
2
low-current cable between the unit and
the control panel. The maximum cable length is 50 m.
The voltage drop for cable lengths over 50 m is too high
and can cause operating errors.
Method of Installation of the Wall Fixture
First screw the fixture securely onto a level wall and then
guide the cable visibly up from below.
Connect the low-current cable to the terminal block.
Check that the cable is connected to the same
numbers at both ends.
(Between the control panel and the main circuit
board in the unit.)
Clip the control panel to the wall fixture by guiding it down
from above, slightly slanting out at the bottom. Finish by
pressing it in at the bottom so that it is flat against the wall.
To disassemble, pull the control panel slightly slanting out
at the bottom and lift up.
Pos.
Description
1
Panel housing
2
Front of panel
3
Pressure plate for display
4
Wall fixture
5
Glass for the display
