Page 6 of 11
Revision A
550-0426
d) Slide sensor clip over edge of bumper or grille.
(Fig. 23)
e) Ensure clip is fully engaged to bumper or grille and that sensor
secure.
f) Replace splash guard if removed.
2. Locate routing point for temperature harness wire on vehicle
firewall. (Fig. 24 or 25)
a) Locate a rubber grommet in firewall that passes through to
passenger compartment and cut a small "X" through it.
(Fig. 24)
- - OR - -
b) Locate hood latch cable grommet in firewall.
(Fig. 25)
3. Route temperature harness to grommet in firewall.
a) Route harness from radiator area, alongside fender to grommet
in firewall.
(Fig. 26)
b) Secure harness to vehicle harnesses in engine compartment
with long wire ties.
(Fig. 27)
4. Route temperature harness into passenger compartment.
a) From inside passenger compartment of vehicle, insert fish-wire
through cut in firewall grommet or cable opening in hood latch
cable grommet, and into engine compartment.
b) Bend approximately 3 inches of harness at terminal end.
c) Using electrical tape, secure fish-wire, to harness.
(Fig. 28)
C
CAUTION
!!
Do not slice outer sealing lip of grommet.
3
C
CAUTION
!!
Ensure routing path is clear of any moving engine parts.
C
CAUTION
!!
Do not route harness near areas of high engine heat.
CAUTION
!
CAUTION
!
24
25
27
28
26
23
