Gentex Active Shooter, Operator'S Manual

Page: 8 / 16

LINER SETUP
Ensure the helmet is properly adjusted for a snug, secure fit at all times when the helmet
is worn. Failure to do so can result in an unstable helmet that will not protect the wearer.
8
WARNING
1
PLACE THE HELMET ON THE HEAD
Leave the chin strap loose for now. Allow the helmet to settle on the head for a few minutes before
checking the fit. Ensure that the front pad is just above the eyebrows. If necessary, adjust the fit as follows:
¼”
Comfort Pads
½ ”
Comfort Pads
¾ ”
Comfort Pads
Helmet too high or too tight:
Remove the ½-inch-thick comfort pads
and install the ¼-inch-thick pads as
shown. Re-check the fit.
Helmet too low or too loose:
Remove the ½-inch-thick comfort pads
and install the ¾-inch-thick pads as
shown. Re-check the fit.
HEADSET PAD CONFIGURATION
For use of the 360
°
Liner in conjunction with a banded headset, simply remove the Comfort Pad located at
the crown as shown below.
Remove