12
Installation Instructions
*Use 350Kpa pressure reduction valve for extended life and better operation
A.
Please flush out new pipe work prior to
connecting the new tapware.
B.
All tapware should be installed with
isolation valves.
C.
The valves are suitable for high pressure
applications where cold water supply
pressures are at a minimum of 150Kpa
and a maximum of 450 Kpa
Important Note for all units
Tapware must be installed to the
requirements of AS/NZS 3500 by a
qualified plumber. Your mixer comes to
you already factory assembled and tested.
We do not recommend the dismantling
of any internal part of the mixer. The
mixers are factory tested and sealed
so as to give the best performance.
Outlet installation instructions
for TFT3500KIT and TFT3600KIT
1.
Allow for a 25mm hole for the water
outlet.
2.
Remove the back nut and washers from
the outlet.
3.
Insert the 15mm thread through the
basin/sink then fix the back nut and
washers in place.
4.
Connect the flexible hose from the
valve outlet to the spout inlet.
Connect
the water supply to operate.
