page 9
Genquip Gi2000 Digital Inverter Petrol Generator
Spark Plugs
1.
Loosen 4 handle screw
(Fig. Q)
and remove handle
(Fig. R)
.
2. Remove spark plug maintenance cover from the generator housing
(Fig. S)
.
3.
Remove the spark plug lead
(Fig. T)
.
4.
Remove any dirt from around the spark plug base.
5.
With the spark plug wrench provided remove the spark plug
(Fig. U)
.
6.
Visually inspect the spark plug. Remove carbon deposits using a wire brush.
7.
Check for discolouration of the top of the spark plug.
The standard colour should be tan colour.
8.
Check the spark plug gap
(Fig. V)
.
Acceptable gap should be between 0.6mm - 0.7mm.
9.
Install / Reinstall the spark plug carefully by hand.
10. Once the spark plug has been seated tighten with the spark plug wrench.
11. Reinstall the spark plug cap on top of the spark plug.
12. Reinstall the spark plug maintenance cover
(Fig. S)
the handles and 4 handle screws.
The recommended spark plugs are as follows : NGK CR7HSA
0.6mm
to
0.7mm
Figure Q.
Figure T.
Figure R.
Figure S.
Figure U.
Figure V.