NOTE: Most users will not have any need to program the controller. This
can be a difficult task, and is not recommended for casual users.
ENTER/EXIT THE PROGRAMMING MODE
To enter or exit the programming mode, hold the right trigger, left
trigger, and sync button at the same time. Keep holding all three
buttons for 5 seconds. You will see the Player 3 and 4 LEDs stay
lit for 2 seconds then turn off. This indicates that you have
entered/exited the programmable mode.
CHANGE RAPID FIRE SPEED
To adjust the rapid fire, you will need to move the right thumbstick
to the left and right. Moving the right thumbstick to the left
decreases the speed, and moving it to the right increases the
speed. The player 4 LED will flash every time you press the right
rigger and the player 3 LED will flash every time you press the left
trigger to indicate you have made a change. Once you have
reached the MIN or MAX speed the LED will no longer flash.
CHECK RAPID FIRE SPEED SETTING
To check the currently set rapid fire speed, tap the sync button.
The player 3 Led will flash the “tens” and position and the player 4
will then flash the single digit. (example. Player 3 flashes 3 times,
followed by the player 4 flashing 6 times, you are now at speed
setting 36) Refer to the table on the next page for all of the speed
settings.
PAGE 3
PROGRAMMING THE RAPID FIRE
Each Rapid fire Mode can be Programmed to one of 50 different speed in-
between 4 shots per second and 50 shots per second. You can also set
the Burst fire for each mode from 2 – 10 shots per burst.
