ENGLISH
Genius Car Alarm
www.geniuscaralarm.com
25
Genius Car Alarms
www.alarmasgenius.com
3
Introduction.
Thank you for purchasing your vehicle for our security. Read through the operating system use
mainly transmitter functions, the valet button and LED indicator board.
The alarm system OEM Genius-5504, was designed and developed for those vehicles that have a
factory original remote control for opening and closing the door locks.
Arming the alarm system.
Arming the alarm system is using 2 methods.
The first through the closed lock button on the remote control, which is necessary for the ignition is
off and the system is not in Valet mode.
The second is the automatic Arm, which is obtained by passing the ignition ON to OFF and then
opening and closing a door. Automatic The system will arm 30 seconds after the last door has
been closed, this function is programmable see table programming functions
Arming the alarm system using the Remote Control.
The alarm system can always be armed by remote control provided the ignition is off and the
system is not in Valet mode.
To arm the alarm system after leaving the vehicle and have closed all doors, simply press and
release the closed lock remote button 1 time, the lights will 1 flash, the siren will give 1 beep and
the LED board begin to flash slowly confirming the system is armed, the locks are closed, the
current cuts will be activated preventing the vehicle can be used past three seconds the alarm
system goes to standby an attempted theft
Armed and Alarm System Activated
.
When the alarm system is armed the LED blinks slowly board, if a door is open, the siren starts to
sound and lights flashing for 60 seconds, if the door remains open after 60 seconds, the siren will
continue to sound and lights detailing for 3 minutes, spent the three minutes the alarm system
excludes sensors doors protecting the vehicle with the other sensors, if the door is closed before
the first 60 seconds after starting the siren, the siren is silenced after 60 seconds and the lights
stop flashing.
If to disarm the alarm system, the siren sounds 4 beeps and lights blink 4 times, this will indicate
that the vehicle suffered an attempted theft, the LED board will continue flashing until you pass the
swiche ignition to the ON position Please check the vehicle well.
Disarming the alarm system
.
When the alarm system is armed, press and release the open lock button on the remote control,
siren sounds 2 beeps and flashes indicating lights 2 disarming the alarm system, cutting ignition
was turned off, the LED board was turned off, the locks of the doors will open.
Exclusion defective areas
.
When arming the alarm system and the defective area, the siren will sound 3 beeps and lights give
3 simultaneous flashes, indicating that an area is found defective, when this happens the faulty
zone will be automatically bypassed and the vehicle remain protected with the rest areas, for
example, if the trunk is not closed at the time of arming the alarm system by transmitter, the siren
will sound 3 beeps and lights flash 3 times indicating that there is a closed area and exclude bad
sensors that area. The defective area will be incorporated into the protection again 3 seconds after
the fault has been corrected.
