9
G
uide
S
ervice
ColorPage-Vivid 1200XE USB
figure 2.4.5.
tweezers to take off the Timing Belt from Module.
To install the Sliding Axle and the Timing Belt,
reverse the steps shown above.
Notice: Ensure that the Timing Belt is installed with the
correct direction as shown in figure 2.4.5.
How to Replace the Motor
figure
2.5.1.
Step 1
Dissolve the green seal on the screws..
Loosen the screws from fixed plate of idle arm with
a screwdriver.
figure 2.5.2
Step 2
Disconnect the connector of the Motor that is
connected to the Scan Board. Then , take off the Motor.
figure 2.5.3.
Step 3
Motor wire fixed method shown as figure 2.5.3.
★
To install the Motor, reverse the steps shown above.
★
Notice: When installing the Motor, please do not turn the screw too tight. And don’t forget to use
the green seal to fix the screw.
Timing Belt
Inside of
belt-fixed
point (A)
Magnify the point of Belt-fixed (A)
Outside of
belt-fixed
point (A)
Motor Line
Summary of Contents for ColorPage-Vivid 1200XE USB
Page 1: ...ColorPage Vivid 1200XE USB...
