Genie ZX-135/70 with Jib-Extend, Operator'S Manual

Page: 51 / 82

Second Edition • Third Printing Operator's Manual
Inspections
Part No. 1272822GT ZX
®
-135/70 49
106 Drive the machine onto a slope where the
chassis angle is greater than 4.5° along the
X-Axis (side to side).
Result: The machine should stop once the
machine reaches 4.5° of chassis tilt and the
alarm should sound at the platform controls.
107 Retract the primary boom to the stowed
position or drive in the opposite direction.
Result: The alarm should turn off and the
machine should drive.
108 Return to level ground and stow the boom.
109 With the boom fully stowed, drive the machine
onto a slope where the chassis angle is
greater than 4.5° along the X-Axis (side to
side).
Result: The machine should continue to drive.
110 Return to level ground and raise the secondary
boom to approximately 5° above horizontal.
111 Drive the machine onto a slope where the
chassis angle is greater than 4.5° along the
X-Axis (side to side).
Result: The machine should stop once the
machine reaches 4.5° of chassis tilt and the
alarm should sound at the platform controls.
112 Lower the secondary boom to the stowed
position or drive in the opposite direction.
Result: The alarm should turn off and the
machine should drive.
113 Return to level ground and extend the jib boom
approximately 12 inches / 30 cm.
114 Drive the machine onto a slope where the
chassis angle is greater than 4.5° along the
X-Axis (side to side).
Result: The machine should stop once the
machine reaches 4.5° of chassis tilt and the
alarm should sound at the platform controls.
115 Retract the jib boom to the stowed position or
drive in the opposite direction.
Result: The alarm should turn off and the
machine should drive.
116 Return to level ground and stow the jib boom.