Genie Z-60/34, Service Manual

Page: 56 / 183

3 - 34 Genie Z-60/34 Part No. 75861
November 2003 Section 3 • Scheduled Maintenance Procedures
REV A
CHECKLIST B PROCEDURES
11 Inspect the housing seals and replace them if
necessary.
12 Install the new filter elements into the housings
and tighten them securely.
The medium and high pressure
filters use the same elements.
13 Clean up any oil that may have spilled during the
installation procedure.
14 Use a permanent ink marker to write the date
and number of hours from the hour meter on the
oil filter housings.
15 Start the engine from the ground controls.
16 Inspect the filter housings and related
components to be sure that there are no leaks.
B-22
Perform Engine Maintenance -
Deutz Models
Deutz engine specifications require
that this procedure be performed
every 400 hours.
Proper engine maintenance, following the engine
manufacturer's maintenance schedule, is essential
to good engine performance and service life. Failure
to perform the maintenance procedures can lead to
poor engine performance and component damage.
Required maintenance procedures and additional
engine information are available in the
Deutz FL 1011F Operation Manual
(Deutz part number 0297 9683).
Deutz FL 1011F Operation Manual
Genie part number
52883
To access the engine:
1 Remove the two engine pivot plate retaining
bolts. Swing the engine pivot plate out away
from the machine and secure it from moving.
Crushing hazard. Failure to secure
the engine pivot plate from moving
could result in death or serious
injury.