Operator's Manual
Seventh Edition · First Printing
10
Z-60/34
Part No. 133083
Do not raise or extend
the boom unless the
machine is on a firm,
level surface.
Do not depend on the
tilt alarm as a level
indicator. The tilt alarm
sounds in the platform
only when the machine
is on a severe slope.
If the tilt alarm sounds
while the boom is
lowered: Do not extend,
rotate or raise the boom
above horizontal. Move
the machine to a firm,
level surface before
raising the platform.
If the tilt alarm sounds when the platform is raised:
Use extreme caution. Identify the condition of the
boom on the slope as shown below. Follow the
steps to lower the boom before moving to a firm,
level surface. Do not rotate the boom while
lowering.
If the tilt alarm sounds with the platform uphill:
1 Lower the primary boom.
2 Lower the secondary boom.
3 Retract the primary boom.
If the tilt alarm sounds with the
platform downhill:
1 Retract the primary
boom.
2 Lower the secondary
boom.
3 Lower the primary
boom.
Do not raise the boom
when wind speeds may
exceed 12.5 m/s. If
wind speeds exceed
12.5 m/s when the
boom is raised, lower
the boom and do not
continue to operate the
machine.
Do not operate the machine in strong or gusty
winds. Do not increase the surface area of the
platform or the load. Increasing the area exposed to
the wind will decrease machine stability.
Use extreme care and
slow speeds while
driving the machine in
the stowed position
across uneven terrain,
debris, unstable or
slippery surfaces and
near holes and drop-
offs.
Do not drive the machine on or near uneven terrain,
unstable surfaces or other hazardous conditions
with the boom raised or extended.
Do not use the machine as a crane.
Do not push the machine or other objects with the
boom.
Do not contact adjacent structures with the boom.
Do not tie the boom or platform to adjacent
structures.
Do not place loads outside the platform perimeter.
Work Area Safety
3
3
