Genie S-80, Service And Repair Manual

Page: 107 / 305

October 2016 Service and Repair Manual
Control System Fault Codes
Part No. 1269074 S-80 • S-85 • S-80X 91
Control Syst em F ault C odes
Error Source Error Type Condition Solution
ID Name ID Name
21 Primary Up /
Down Joystick 11 Value at 5V Function is inoperative.Alarm sounds
indicating a fault. Cycle power off, then on
after problem has been
corrected.
12 Value too high
15 Value too low
16 Value at 0V
17 Not calibrated Calibrate joystick.
22 Primary Up /
Down Directional
Valves 21 Fault Valve is operating outside of limits. Cycle power off, then on
after problem has been
corrected.
Alarm sounds indicating a fault.
23 Primary Up /
Down Flow Valve 12 Value too high Valve is operating outside of limits. Cycle power off, then on
after problem has been
corrected.
15 Value too low Alarm sounds indicating a fault.
17 Not calibrated Normal function except threshold for
one or both directions is zero. Calibrate valve threshold.
24 Angle sensor 11 Value at 5V Reduced speed function. Cycle power off, then on
after problem has been
corrected.
12 Value too high Alarm sounds indicating a fault.
15 Value too low
16 Value at 0V
17 Not calibrated Calibrate angle sensor.
31 Invalid setup Initiate 1 -second beep of Alarm Buzzer
and required retract into safe envelope Calibrate angle sensor.
26 Angle sensor
cross check 19 Out of range Reduced speed, required retract into
safe envelope Power up controller with
problem corrected
31 Secondary Up /
Down. Joystick 11 Value at 5V Function is inoperative. Alarm sounds
indicating a fault. Cycle power off, then on
after problem has been
corrected.
12 Value too high
15 Value too low
16 Value at 0V
17 Not calibrated Calibrate joystick.