9
WARNING
M
AINTENANCE AND
A
DJUSTMENTS
Be sure the carriage is disengaged from the belt before
performing the following portion of theSafety-T-Beam®
testing.The carriage is disengaged when the release
lever is pointing down (
Figure 4
).
Step
2:
P
ROGRAMMING
R
EMOTE
C
ONTROLS
WARNING
B
Check the reverse function.
•
Check that the Carriage is disengaged (
Figure 4
).
•
Press the wall button to move the bullet (
Figure 5
) to the
open position (away from the door) (
Figure 4
).
– Observe the belt as it travels and adjust tension
if necessary.
•
Press the wall button to start the bullet in the close direction.
•
Block theSafe-T-Beam® while the bullet is moving toward
the door (
Figure 6
).
– The bullet must stop and reverse direction when the
beam is blocked.
C
Check the forced closure feature (
Figure 7
).
•
Block theSafe-T-Beam®.
•
Press the wall button and verify that the bullet moves in
the close direction as long as you hold the button but
reverses whenever you let go of the button (
Figure 7
).
A moving garage door may cause serious injury or death.
·
Keep people clear of opening while door is moving.
·
Do not allow children to play with Remote Controls.
If theSafetyReverse does not work properly:
·
Close the door and disconnect the Opener using
theEmergencyRelease Cord.
·
Do not use the door Opener,Remote Controls, or
WirelessKeypad.
·
Refer to the door and door Opener Owner
’s
Manuals before attempting any repairs.
·
Stay clear of the opener's belt, the door and any
other moving parts when operating the opener
with a remote control.
A
To Program one Button of aRemote Control
•
Locate Learn Button and Learn Indicator Light on side of
Power Head (
Figure 1
).
Figure 4
Disengage carriage
Figure 5
observe bullet travel
Figure 1
Learn Code Button and Indicator Light
•
Pressand release Learn Button.Red Learn Indicator Light will
blink 2 times per second.
•
PressRemote Control Button once within 30
seconds(
Figures 2 and 3
). Red Learn Indicator Light will
stay lit.
•
PressRemote Control Button again.Red Learn Indicator Light
will go out, indicating that memory isstored.
B
Program each additional Remote using step
A
above.
BLOCKTHEBEAM
WHILETHEBULLET
IS MOVING DOWN.
315 Mhz
Frequency
Switch
390 Mhz
Frequency
Switch
Figure 6
Block the beam
1 Button Compact Remote
w/Docking Station
3 Button Compact Remote
w/Docking Station
PLACEAN OBJECT IN
THEBEAM
’SPATH.
Figure 7
Block the beam
Figure 2
GenieRemote Controls
NOTE
Only one remote button can be entered at a time.Repeat
A and B for each remote button to be programmed.
Summary of Contents for Quietlift 2M
Page 5: ...5 Figure1 Checking door balance...
Page 15: ......
