Genie Quietlift 2M, Operation And Maintenance Manual

Page: 10 / 18

1
0
C Remote Control Operation.
•
PressButton on Remote Control. Garage door will move.
•
PressButton again. Garage door will stop:
The door automatically stops at the end of the open or
close cycle.
•
PressButton again. Garage door will reverse.
•
SomeRemote Controls are equipped with a flashlight.The
Genie logo is the button which operates the light.There is a
backlight under the button. When it does not light, it
indicates the battery needs replaced.
AND GO OUT
Frequency
Flashlight Button
Switch
Figure 4 Erasing the remotes
NOTE
If the light on the remote glows dimly or does not light
when operating the remote, replace the batteries.
1 Button
Remote
w/Flashlight
3 Button
Remote
w/Flashlight
3 Button
Large
Remote
w/Flashlight
E Replacing the batteries.
•
Pop off the back of the transmitter using a coin.
•
Replace the battery with a new compatable coin
type battery.(size 2032)
•
Snap the back of the transmitter on.
Figure 3 GenieRemote Controls
NOTE
Transmitter Compliance Statement
•
Each Remote Control must be programmed separately.
•
TheRemote Controls will not cause the door Opener to close
the garage door if theSafe-T-Beam®System is malfunctioning.
•
When Programming theRemote Controls, they must be at
least
24” from the AntennaWire.
•
If the red Learn Indicator Light blinks approximately 4 times
per second, programming hasstopped, repeat the above steps.
•
Each Button on a 2 or 3 Button Remote Control is for a
different Opener.You cannot use more than one Button per
Remote, per Opener.
•
A maximum of seven Remote Controls or WirelessKeypads
can be stored into theReceiver at one time. If aRemote
Control becomes lost, or if you want to delete aRemote
Control or Wirelesskeypad,see
“To Erase all Receiver Memory”
CAUTION
Should a remote become lost orstolen it isimperative that
the remotecontrol codesbeerased from the receiver
memoryand new codesprogrammed, to prevent the
missing remote from being able to operate the door opener.
D Erasing all remotes ( Figure 4 ).
•
Pressand hold Learn Button on Power Head until Learn
Indicator Light goes out. Memory is erased.
•
Program receiver again as needed.
9