7 - 38
Genie Z-30/20
Part No. 43063
Service Manual - Third Edition
Section 7 - Repair Procedures
3 Press the bearing grease seal evenly into the
hub until it is flush.
4 Apply a small amount of grease onto the yoke
spindle.
5 Slide the hub onto the yoke spindle.
Component damage. Do not
apply excessive force or damage
to the lip of the seal may occur.
6 Place the outer bearing into the hub.
7 Install the washer and castle nut.
8 Tighten the castle nut to 35 foot-pounds
(47 Nm).
9 Loosen the castle nut, then re-tighten to
8 foot-pounds (11 Nm).
10 Install a new cotter pin. Bend the cotter pin
to lock it in.
11 Install the dust cap, then the tire and wheel
assembly. Torque the wheel lug nuts to
125 foot-pounds (169.5 Nm).
STEERING AXLE COMPONENTS
9-2
Steering Cylinder
How to Remove a
Steering Cylinder
1 Tag, disconnect and plug the hydraulic hoses
from the steering cylinder. Cap the fittings on
the cylinder.
Bodily injury hazard. Spraying
hydraulic oil can penetrate and
burn skin. Loosen hydraulic
connections very slowly to allow
the oil pressure to dissipate
gradually. Do not allow oil to
squirt or spray.
2 Remove the cotter pins from the clevis pins at
each end of the steer cylinder. Then remove
the clevis pin from each end of the steering
cylinder.
3 Remove the steering cylinder.
Always use a new cotter pin when
installing a clevis pin.
9-3
Tie Rod
How to Remove the Tie Rod
1 Remove the cotter pin from both clevis pins,
then remove the clevis pin from each end of
the tie rod.
2 Remove the tie rod.
Always use a new cotter pin when
installing a clevis pin.
