4
Only original spare parts can be used for repair
Casing should never be disassembled while power is on
Avoid electronic system to be splashed with water
In case of heater’s defect or improper work switch off power and shut off water supply
using stopping – suppressing valve.
Water tap drain tube sprinkler (strainer) should be cleaned regularly.
Power supply system should be periodically checked up (voltage drops), particularly
electrical connections.
Water flow should be suppressed in such way to avoid excessive temperature (take
care of children).
This appliance is not intended for use by persons (including children) with reduced
physical, sensory or mental capabilities, or lack of experience and knowledge, unless
they have been given supervision or instruction concerning use of the appliance by a
person responsible for their safety.
Children should be supervised to ensure that they do not play with the appliance.
3. Wiring system
The heater can only be used previously connected to earthing system.
Wiring system should be equipped with differential switch.
Minimum wire cross section and fuse value should be selected according to table 3.
Before heater’s installation check state of wiring system and particularly terminal.
After heater’s connection to wiring system measure voltage drop under load
Fig.2
Table 3
Type
Genie
H20
3500
Genie
H20
4000
Genie
H20
4500
Genie
H20
5000
Genie
H20
5500
Minimum wire cross section
[mm²]
1.5
2.5
2.5
2.5
2.5
Current intensity [A]
15.2
17.4
19.6
21.7
23.9