Genesis GLMT08B, Operator'S Manual

Page: 8 / 36

English
8V Lithium-ion Oscillating Tool
Operator’s Manual GLMT08B
UNPACKING AND CONTENT
IMPOrTANT
:
Due to modern mass production techniques, it is unlikely the product
is faulty or that a part is missing. If you find anything wrong, do not operate the tool until
the parts have been replaced or the fault has been rectified. Failure to do so could result
in serious personal injury.
CONTENTS IN PACKAGE
:
Description QTY Description QTY
Oscillating Tool 1 Battery Pack (GLAB08B) 1
Charging Stand 1 Charging Adaptor 1
Detail Sanding Pad 1 Sandpapers 12
Flush-Cut Blade 1 Allen Wrench 1
Storage Box 1 Operator's Manual 1
ASSEMBLY AND ADJUSTMENTS
WArNING:
To reduce the risk of serious personal injuries, read and follow all
important safety warning and instructions before using this tool.
WArNING:
Always be sure that the tool is switched off before insertion or
removal of the battery pack.
INSTALLING OR REMOVING THE BATTERY
PACK (FIG 2)
• To install the battery pack, insert the battery pack (2) into the
bottom of the tool all the way until it locks in place with a click,
as shown in FIG 2.
• To remove the battery pack, slide the battery locking tab (3) as
shown in FIG 2, to release the battery pack, then remove the
battery pack.
INSTALLING AND REMOVING ACCESSORIES (FIG 3)
WArNING:
Always disconnect battery pack from tool or place the switch in
the locked or off position before any assembly, adjustments or changing accessories.
To Install the Accessories
1. Loosen and remove the cap screw (a) and the washer (b) from
the shaft flange (4) using Allen wrench (8) provided.
2. Place the accessory over the shaft flange. The shaft flange of
this tool comes with a 6-pin design. Make sure the holes on the
accessory properly engage those 6 pins and the accessory is
flush against the shaft flange.
3. Put the cap screw and the washer back on. Make sure the
concave side of the washer is facing the accessory. Tighten the
cap screw securely using Allen wrench. See FIG 3.
4. When using the sandpaper, install the sanding pad first. Align
the sandpaper and press it onto the sanding pad by hand. Turn
the tool over, and firmly press the sandpaper against a flat
surface to secure it.
NOTE:
Some accessories, such as a saw blade, may be mounted either straight on the tool, or at an angle to
enhance usability. Always make sure the 6 pins are engaged as described in step 2 above.
WArNING:
DO NOT tighten the cap screw unless the accessory is
properly seated on the shaft flange.
To Remove the Accessories from the Tool
,
simply just reverse the above procedures.
8
FIG 2
2 3
FIG 3
4
b
a
8