MO
UNTING TYPE "
B
" & "
C
"
20.
After the blind is installed w
e recommend filling the upper and side
gaps between the wall and the roller shutter with silicone seals for
protection against water. Blinds above 200 cm it is recommended to
screw the roller shutter box to the header using flat head screws
every 100 cm.
MOUNTING TYPE "B" & "C"
o
6
o
10
o
10
o
6
o
10
MOSQUITO NET WITH KLIK-KLAK
... after unscrewing the Allen screws with the 2mm key, please
use
a
screwdriver to move the hooks up or down. In the case of
the KLIK-KLAK system, unscrew the screw with the key 3mm
hexagon socket and set to the desired height
.
1.
Drill the holes in the guides. Use a 6mm drill bit to drill a hole through the two guide chambers and a 10mm drill bit
increase the opening in the first chamber only from the outer side of the guide (TYPE OF ASSEMBLY C - increase the hole in the middle wall
the guide).
3.
Place the drilled guides against the wall and mark the holes
for screws on the window frame.
4.
Place the drilled guides to the wall and mark
holes for mounting
screws in the side of the opening
6
When installing external blinds with mosquito nets in installation type B (in
the opening
) in some cases
it may happen that the handles of the bottom bar of the mosquito net can be he
ld
by the window frame. Then it
is recommended installation of blinds on spacing strips or removal of holders, and
change from
the bottom slat
gasket mosquito screens from the side channel to the bottom channel. Handles located in the bottom strip of the
mosquito net are not indispensable element but facilitate the use of mosquito nets
.
MOUNTING "B"
MOUNTING "C"
MOUNTING "B"
MOUNTING "C"
myeuropeanwindows.com
