22
10.) Place catalyst panel back into DT-FP. Be sure that arrows on panel point in the direction of air
flow. See Figure 9.
Note:
Air flows through catalyst panel first, then through fan motor housing.
11.) Using MOLEX connectors or wire nuts, wire catalyst panel in the same way they were originally
wired. See Figures 7 and 8.
12.) Before reattaching cover, check to make sure that lamps operate. Reconnect unit to power and
turn on. Briefly press in safety switch with your hand or with a tool. If lamps are operating correctly, a
green glow will illuminate from green lamp sleeve.
Caution:
Exposure to UV light is dangerous. Be sure to wear proper PPE when inspecting lamps.
See page 9.
13.) Once lamp operation is verified, reattach access cover. Reinsert (6) screws and tighten with a
Phillips-Head screwdriver.