48
Englis
h
6.1 Use of the 230V de AC outlet.
NOTE:
Do not start the generator with loads connected. to disconnect
them from the panel or are sure the switches of equipment are in OFF status,
so that the generator starts without loads
.
Start the engine following the steps indicated in this manual.
Once started, verify that the BREAKER is in the "ON" position as below picture,
now you can connect your devices.
WARNING:
Confirm that all electrical devices are in good work conditions
before plugging them to the generator.
If an electrical device is not working properly, is slow or stops suddenly, turn
off the engine immediately and unplug the device.
6.2 Equipment overload and restart.
In case of an overload or short circuit the overload protection "BREAKER" will
switch to the "OFF" position, disconnecting the voltage output.
In case of overload, first unplug any plugged equipments. Once the
equipments are unplugged, assemble the overload protector again by rising
the protector to the "ON" position to restore the group voltage output.
If the overload protector trips again after connecting the devices, do not plug
the device. The plugged device may have a problem or exceeds the
generator's power.
NOTE
: Once you verify that the generator cannot support or accept the
load, please do not insist. Constant overloads may negatively affect the group
.
