FIGURE 13
6) Install the tool retainer to the tool receiver assembly.
The tool retainer incorporates a right hand thread
configuration. Tighten by hand only until the retainer
bottoms against the plastic gasket. Do not operate the
Long Reach Air Tool without a tool receiver gasket of
proper structural integrity and without the tool retainer
properly attached to the tool receiver assembly.
HAND TIGHTEN THE TOOL RETAINER AGAINST
THE TOOL RECEIVER GASKET BY HAND ONLY.
USE OF A WRENCH CAN RESULT IN DAMAGE TO
THE THREADED COMPONENTS.
DO NOT OPERATE THE LONG REACH AIR TOOL
WITHOUT THE TOOL RETAINER PROPERLY
ATTACHED TO THE TOOL RECEIVER ASSEMBLY.
WITHOUT THE TOOL RETAINER PROPERLY
ATTACHED TO THE TOOL RECEIVER ASSEMBLY,
SIGNIFICANTLY REDUCED OPERATOR CONTROL
OF THE ACCESSORY TOOL WILL RESULT. SUCH
OCCURRENCE CAN RESULT IN PROPERTY
DAMAGE AND/OR PERSONAL INJURY.
7) Accessory tool removal is accomplished by
reversing the installation process. The PN MDF15-
7010 Service Tool can be utilized to help separate the
retaining bushing from the tool retainer. A 1/8 inch long
handle Allen wrench can also be utilized. FIGURE 14.
FIGURE 14
ATTACHING THE LONG REACH AIR TOOL TO THE
AIR CADDY AND AIR HOSE ASSEMBLIES.
1) Position the Long Reach Air Tool and installed
accessory tool on a suitable horizontal surface that
allows the throttle control valve to be protected from
unexpected actuation by an external force.
UNEXPECTED THROTTLE VALVE ACTUATION
FROM AN EXTERNAL FORCE CAN RESULT IN
PROPERTY DAMAGE AND/OR PERSONAL INJURY.
2) Disconnect the air hose from the compressed air
source.
3) Turn the screw located on the bottom of the
pressure regulator out in a counterclockwise direction
to release pressure from the internal diaphrarm.
Variances in specific design configurations can exist.
Do not allow the screw to separate from the regulator.
FIGURE 15.
MDF SERIES LONG REACH AIR TOOLS FORM GOM6019801, VERSION 1.0, AUTHORIZATION: DVR, PAGE: 18
Summary of Contents for MDF15
Page 2: ......
