JOB APPLICATION AND THAT IT WILL HAVE
SUFFICIENT POWER AND PRODUCTIVITY TO
PERFORM ANY SPECIFIC JOB APPLICATION.
IT IS THE RESPONSIBILITY OF THE OPERATOR(S)
AND/OR OWNER(S) OF THE LONG REACH AIR
TOOL TO DETERMINE OPERATION FOR ANY
SPECIFIC JOB APPLICATION IS IN COMPLIANCE
WITH ALL APPLICABLE OSHA AND/OR EPA
REGULATIONS REGARDING ITS USE.
CALIFORNIA PROPOSITION 65 DISCLAIMER
.
Applications: All models.
DUSTS AND BYPRODUCTS FROM THE
OPERATIONAL PROCESS OF THIS PRODUCT
CONTAIN CHEMICALS KNOWN TO THE STATE OF
CALIFORNIA
TO CAUSE CANCER, BIRTH
DEFECTS, OR OTHER REPRODUCTIVE HARM.
SAFETY RELATED EQUIPMENT AND APPAREL
DISCLAIMER.
OPERATION OF THE LONG REACH AIR TOOL
REQUIRES THE USE OF SPECIFIC SAFETY
RELATED EQUIPMENT AND APPAREL
INCLUDING, BUT NOT LIMITED TO: SAFETY
EYEWEAR, HARD HAT, HEARING PROTECTION,
PROTECTIVE BREATHING MASK, ANTI-
VIBRATION GLOVES, SAFETY CLOTHING AND
SAFETY FOOTWEAR. IT IS THE RESPONSIBILITY
OF THE OWNER(S) AND/OR OPERATOR(S) TO
DETERMINE THE REQUIRED AND/OR
APPROPRIATE SAFETY RELATED EQUIPMENT
AND APPAREL
FOR ANY
SPECIFIC JOB
APPLICATION. FAILURE TO WEAR THE
REQUIRED AND/OR APPROPRIATE SAFETY
RELATED EQUIPMENT AND APPAREL FOR ANY
SPECIFIC JOB APPLICATION CAN RESULT IN
PROPERTY DAMAGE AND/OR PERSONAL INJURY.
INFORMATION RELATIVE TO MINIMUM
COMPONENT STANDARDS FOR THE OPERATION
OF THE LONG REACH AIR TOOL.
For operational safety and overall productivity
considerations, it is required that specific Long Reach
Air Tool components meet minimum acceptable
operational standards BEFORE utilization:
1) The air hose assemblies and coupling devices are of
proper type and structural condition that allow them to
perform their intended job function as outlined within
this manual.
2) Throttle valve control is in a proper mechanical
condition that allows it to perform its intended job
function as outlined in this manual. A throttle valve with
a damaged or bent lever, a sticking or damaged valve
mechanism must be replaced with a factory approved
replacement only.
3) The protective cover for the throttle valve control is
in proper structural condition to afford protection for the
valve in the event it comes in direct contact with a
foreign object, thereby preventing inadvertent
actuation.
4) The tool receiver is in a structural condition that
allows it to perform its intended job function of properly
containing the accessory tool shank as outlined within
this manual.
5) The tool retainer assembly (cover and retaining
bushing) is in a structural condition that allows it to
perform its intended job function of properly retaining
the accessory tool as outlined within this manual.
OPERATION OF A LONG REACH AIR TOOL
UTILIZING COMPONENTS NOT MEETING
MINIMUM COMPONENT STANDARDS CAN
RESULT IN PROPERTY
DAMAGE AND/OR
PERSONAL INJURY.
SET UP FOR OPERATION.
Applications: All models.
In order to minimize the possibility of damage to the
Long Reach Air Tool, always transport it to the job site
disconnected from the air hoses and/or Air Caddy. All
equipment must be secured in/on vehicles with
suitable strapping or tie downs. Personnel should not
be transported in the same compartment as equipment
and fuel supplies. Consult applicable OSHA
regulations.
1) The Long Reach Air Tool is designed to be utilized
by one operator.
MDF SERIES LONG REACH AIR TOOLS FORM GOM6019801, VERSION 1.0, AUTHORIZATION: DVR, PAGE: 15
Summary of Contents for MDF15
Page 2: ......
