tool. The end of the male hexagon shank should be
flat and perpendicular to the axis of the tool. FIGURE
10. Properly discard any tool of a bent, crowned or
"mushroomed" configuration.
FIGURE 10
USE OF AN ACCESSORY TOOL OF IMPROPER
SIZE AND/OR CONFIGURATION FOR THE
INTENDED JOB APPLICATION, OR AN
ACCESSORY TOOL WHICH IS WORN AND/OR
DAMAGED CAN RESULT IN PROPERTY DAMAGE
AND/OR PERSONAL INJURY.
3) Remove the tool retainer from the barrel. The tool
retainer incorporates a right hand thread configuration.
Remove the retaining bushing. FIGURE 11.
FIGURE 11
4) Insert the male hexagon shank of the accessory tool
through the opening of the tool retainer. Install the
retaining bushing over the round shank of the
accessory tool with the shoulder of the retaining
bushing against the upset collar. The retaining bushing
incorporates a split to facilitate installation. FIGURE
12.
D
O NOT OPERATE THE
L
ONG
R
EACH
A
IR
T
OOL WITHOUT THE
PROPER RETAINING BUSHING INSTALLED WITHIN THE TOOL
RETAINER
. U
SE OF THE
L
ONG
R
EACH
A
IR
T
OOL WITHOUT
THE PROPER RETAINING BUSHING INSTALLED CAN RESULT IN
PROPERTY DAMAGE AND
/
OR PERSONAL INJURY
.
FIGURE 12
5) Install the male hexagon shank of the accessory tool
into the tool receiver. If the accessory tool is of a chisel
configuration, determine the desired orientation of the
chisel blade in relationship to the throttle valve control
to facilitate maximum comfort and control during
operation. FIGURE 13.
MDF SERIES LONG REACH AIR TOOLS FORM GOM6019801, VERSION 1.0, AUTHORIZATION: DVR, PAGE: 17
Summary of Contents for MDF15
Page 2: ......
