General Excalibur 40-200C, Setup & Operation Manual, Page: 19 / 38

ASSEMBLY INSTRUCTIONS -
40-130 DUST COLLECTION KIT
SERIOUS PERSONAL INJURY COULD OCCUR IF YOU CONNECT THE MACHINE TO THE POWER SOURCE BEFORE YOU HAVE COM-
PLETED THE INSTALLATION AND ASSEMBLY STEPS. DO NOT CONNECT THE MACHINE TO THE POWER SOURCE UNTIL INSTRUCTED
TO DO SO.
Note: There are three longer screws in the hardware kit that are required to attach the 4 inch hose adapter. Locate them
first. You will find additional mounting hardware to attach the 40-130 dust enclosure to the table. This additional hardware
will not be required with cast-iron table for 40-200C because the same fasteners are supplied with the table.
2. Assemble dust enclosure as shown, using the 22
short phillips head screws.
40-130 DUST COLLECTOR
SIDE SIDE BOTTOM
REAR FRONT
19
7. Using the supplied hose clamps, secure one end
of the dust hose to the 2 1/2” inlet on the dust port
A and the other end ot the dust outlet on the fence, B .
8.
The vent on the dust enclosure allows you to adjust
airflow and maximize dust collection efficiency
based on the size of your dust collector. The smaller
the dust collector the wider the vents should be
opened to allow maximum airflow.
Note: To prevent overheating the router motor inside the
confined space of the enclosure, always use a dust col-
lector or vacuum to allow for air to flow.
B
A
40-130 DUST COLLECTOR
A B
5.
Position and secure the dust enclosure into place
A
using the 6 hex head bolts with lock washer and flat
washer
B
.
6. Turn the assembly back over to its upright and oper-
ating position.
3.
T
urn the assembled router table upside down.
4. Remove the 6 he
x
head bolts from the underside of
the table. (40-200C and 40-200P only)
Note: For #40-049 MDF table (for #40-200M), use the wood
screws supplied with your table to attach the dust collec-
tion box to the table.