General Excalibur 40-200C, Setup & Operation Manual, Page: 15 / 38

ASSEMBLY INSTRUCTIONS -
#40-080 ROUTER FENCE
SERIOUS PERSONAL INJURY COULD OCCUR IF YOU CONNECT THE MACHINE TO THE POWER SOURCE BEFORE YOU HAVE
COMPLETED THE INSTALLATION AND ASSEMBLY STEPS. DO NOT CONNECT THE MACHINE TO THE POWER SOURCE UNTIL
INSTRUCTED TO DO SO.
2.
Remove the original 8 fence bracket mounting bolts
A from the table and attach the fence mounting
brackets to the underside of the table,
B
.
4.
Insert an orange plastic spacer
A
with the short end
down on one short T- bolt B , then insert the head of
the bolt in the front upper slot in the fence body as
shown in C .
A
B
C
A
B
D
1.
Attach the two fence side rails with scale
A
to their
mounting brackets B , using 3 hex head bolts with flat
washers and square nuts
C
, in the assembly order
shown in D .
Note: The hex head bolts and square nuts supplied with the
fence are coarse thread and the hex head bolts supplied
to attach the #40-130 Dust Enclosure are fine thread.
15
A
B
Before opening the fence, have a clear work area to prevent the mixing of hardware.
C
3.
Attach the second mounting bracket to the oppo-
site side of the table, A .
Note: Adjust the height of the 3 bolts in the slotted holes in
the rail bracket so that the rail is leveled with the table,
B
.
CAST-IRON TABLE #40-200C AND PHENOLIC TABLE #40-200P ONLY)*
Note: You will find 6 additional side bracket mounting fasteners in the fence hardware to attach the side brackets to the
cast iron table. These will not be required if you have purchased a complete kit, because the same fasteners have been
supplied with the table top.
For #40-049 MDF table (for #40-200M), use the wood screws supplied with your table to attach the mounting brackets
to the table.
*
A
B