ASSEMBLY INSTRUCTIONS -
ATTACH THE STAND TO THE TABLE
SERIOUS PERSONAL INJURY COULD OCCUR IF YOU CONNECT THE MACHINE TO THE POWER SOURCE BEFORE YOU HAVE COM-
PLETED THE INSTALLATION AND ASSEMBLY STEPS. DO NOT CONNECT THE MACHINE TO THE POWER SOURCE UNTIL INSTRUCTED
TO DO SO.
CAST-IRON TABLE #40-200C AND PHENOLIC TABLE #40-200P ONLY)*
* For #40-049 MDF table (for #40-200M), use the wood screws supplied with your table to attach the stand to the
table.
1.
With the table upside down, remove the 4 mounting
screws and washers,
A
for the stand.
2.
Attach the stand to the table using the four socket
head cap screws and washers,
B
, then tighten.
CAST-IRON TABLE 27”X 16”
#40-070
Note: If you previously threaded all the fasteners into the
underside of the cast-iron table, the leveler screws will
already be in place. If you didn’t, thread them in now. The
nut will sit on the top side of the flange that the router lift/
plate will rest on.
A
B
The stand caster system allows you to engage/dis-
engage the stand casters in order to move the router
table as needed within the shop.
-
Push the pedal down to engage the stand casters.
-
Pull the pedal up to disengage the stand casters.
ENGAGING/DISENGAGING THE STAND CASTERS
NEVER MOVE THE ROUTER TABLE WHILE THE ROUTER
IS RUNNING AS THIS CAN LEAD TO SERIOUS INJU-
RIES. ALWAYS MAKE SURE THAT THE WHEELS OF
THE STAND HAVE BEEN DISENGAGED AND THAT THE
STAND HAS BEEN COMPLETELY IMMOBILIZED BEFORE
TURNING ON THE ROUTER AND STARTING TO CUT.
14
3.
Turn the stand and table assembly upright and
tighten all bolts, checking that the table is level with
the floor. Adjust the leveling feet as needed.
Summary of Contents for Excalibur 40-200C
Page 29: ...29 Notes...
Page 33: ...33 Stand 40 085...
Page 34: ...PART N0 REF NO DESCRIPTION SPECIFICATIONS QTY PARTS LIST 40 085 NOTES 34...