En-3
Fig. 1 Indoor Unit
1
Intake Grille
2
Open Panel
3
Air Flow Direction Louver
4
Right-Left Louvers
(behind Air Flow Direction Louver)
5
Indicator (Fig. 2)
6
Indoor Temperature Monitor Indicator
7
OPERATION Indicator Lamp
8
TIMER Indicator Lamp
●
If the TIMER Indicator Lamp flashes when
the timer is operating, it indicates that a
fault has occurred with the timer setting
(See page 20 Auto Restart).
9
SWING Indicator Lamp
0
Clean Air Indicator
A
Remote Control Signal Receiver
B
HI-POWER Indicator Lamp
C
Power Supply Cord
D
Power Supply Plug
E
Drain Hose
F
Clean Air Indicator Sensor
G
Air Filter
H
Plasma Dust Collector Unit
I
MANUAL AUTO button
J
Light-regenerated Deodorizing Filter
Fig. 4 Outdoor Unit
K
Intake Port
L
Outlet Port
M
Drain Port
N
Pipe Unit
Fig. 5 Remote Control Unit
O
SLEEP button
P
MASTER CONTROL button
Q
SET TEMP./SET TIME buttons (
)
R
Signal Transmitter
S
TIMER button
T
FAN CONTROL button
U
START/STOP button
V
AIR FLOW DIRECTION button
W
SWING LOUVER button
X
HI-POWER button
Y
AIR CLEAN button
Rear side (Fig. 6)
Z
TIME ADJUST button
[
ACL button
\
TEST RUN button
●
This button is used when installing the
conditioner, and should not be used un-
der normal conditions, as it will cause the
air conditioner’s thermostat function to op-
erate incorrectly.
●
If this button is pressed during normal op-
eration, the unit will switch to test opera-
tion mode, and the Indoor Unit’s OPERA-
TION Indicator Lamp and TIMER Indicator
Lamp will begin to flash simultaneously.
●
To stop the test operation mode, either
press the TEST RUN button once again, or
press the START/STOP button to stop the
air conditioner.
]
Remote Control Unit Display (Fig. 7)
^
Transmit Indicator
a
Clock Display
b
Operating Mode Display
c
Timer Mode Display
d
Fan Speed Display
e
Temperature Set Display
f
Timer Set Indicator
g
Temperature Set Indicator
NAME OF PARTS
•
Refer to the fold-out on the cover.
INDOOR TEMPERATURE DISPLAY
•
The displayed temperature can only be used for reference. Depending on the intake air temperature, installing condition or
operating status of the indoor unit, it may be different from the actual indoor temperature. (See Fig. 2
6
).
•
When the unit is operating, indoor temperature display will light up continuously. However, in order to view the indoor
temperature, it cannot be displayed in the first minute after starting the operation. Under this condition, indoor temperature
display will display
.
•
Indoor temperature can display temperature from –9
°
C ~ 45
°
C. When the temperature is lower than –9
°
C, indoor tempera-
ture display will display
. When the temperature is higher than 45
°
C, indoor temperature display will display
.
Все каталоги и инструкции здесь:
http
:
//splitoff.ru/tehn-doc.html