En-14
Make sure the dust collection unit is properly mounted before cleaning or performing other tasks
on it. If the unit is not properly mounted, it could fall off and cause damage or injury.
The display section for the clean air indicator will flash when it is time for the periodic cleaning of the dust collection unit.
• When the flashing of the display section for the clean air indicator is slow (approximately 1 flash every 4 seconds)
This will flash after approximately 400 hours of operation. Cleaning of the dust collection unit as soon as possible is
recommended.
•
When the flashing of the display section for the clean air indicator is fast (approximately 1 flash every 2 seconds)
This will flash after approximately 500 hours of operation. Stop the air cleaning operation and clean the dust collection
unit.
●
As a guideline, clean every 6 months.
●
If unusual sounds (like the rushing of air or popping) are heard, clean the dust collection unit as quickly as possible.
●
If the air cleaning check function is operating, open the intake grille and press the MANUAL AUTO button.
CLEANING THE PLASMA AIR CLEANING FILTER
CAUTION!
Removing the dust collection unit
1. Use the remote controller to stop opera-
tion and unplug the power cord.
2. Open the intake grill and remove the right-
side air filter. (Refer to page 13.)
3. Remove the dust collection unit.
(Note that the figure below shows the unit without the
grille. This is for explanatory purposes only. The actual
intake grille cannot be removed.)
Grasp the handle of the dust collection unit. Pull up
(shown as direction
1
) and then pull down (shown as
direction
2
) to remove.
Handle
Cleaning the dust collection unit
Wash with water and dry.
1
Soak the dust collection unit in warm water (40 to 45
°
C) for 10 to 15 minutes. If the dust collection unit is
extremely dirty, extremely dilute a mild synthetic laun-
dry detergent (low or neutral alkalinity) to 15 times
the standard concentration and allow the dust collec-
tion unit to soak in it.
2
Gently move up and down and to the right and left. A
soft sponge can also be used to wipe the rear sur-
face.
3
Rinse with clean water.
4
Shake the dust collection unit to drain off the water.
(If the dust collection unit is extremely dirty, repeat
Steps
1
through
4
two or three more times.)
5
Place the dust collection unit in the shade and allow
it to dry completely.
●
Only use a mild synthetic laundry detergent (low or
neutral alkalinity).
●
Never disassemble the dust collection unit.
●
Never soak the dust collection unit in hot water.
●
Never wipe the dust collection unit with a scrub brush
or other hard or abrasive items.
●
Never insert a brush into the inside of dust collection
unit for washing. This will damage the thin fibers in-
side and cause malfunctioning of the air cleaning unit.
●
Never use dryer or other device to blow hot air on the
dust collection unit. This will cause deformation or
other damage.
Все каталоги и инструкции здесь:
http
:
//splitoff.ru/tehn-doc.html