En-15
Mounting the dust collection unit
1. Mount the dust collection unit.
(Note that the figure below shows the unit without the
grille. This is for explanatory purposes only. The actual
intake grille cannot be removed.)
1
Insert both of the insert sections of the dust collec-
tion unit into the guide rail.
Guide rail
Insert sections (2 locations)
2
Insert all the way to the back and then press in the
two tabs on the lower part until they snap into place.
Tabs (2 locations)
Snap
●
Make sure the dust collection unit is completely dry
before mounting it.
●
After the dust collection unit has been mounted into
place, make sure that the tabs on both sides are se-
curely inserted in the frame. If the dust collection unit
is not properly mounted, the red operation lamp and
green timer lamp will flash, a
will be displayed in
the temperature monitor and the air cleaning opera-
tion will stop.
CLEANING THE PLASMA AIR CLEANING FILTER
2. Mount the air filter and close the intake
grille. (Refer to page 13.)
●
After cleaning the dust collection unit, if the red oper-
ating lamp and green timer lamp flash and a
is dis-
played in the monitor, check if the dust collection unit
is wet or if the intake grilles is closed tightly.
●
If the dust collection unit is completely dry and the in-
take grille is closed tightly but the lamps still flash, it is
probably due to damage to the dust collection unit.
The dust collection unit must be replaced. Contact your
sales representative for more information.
Snap
Все каталоги и инструкции здесь:
http
:
//splitoff.ru/tehn-doc.html