General 80-125L, Setup & Operation Manual

Page: 9 / 32

Carefully unpack and remove the jointer, its components and tools from its shipping container and check for mis-
sing or damaged items as per the list of contents below.
NOTE: Please report any damaged or missing items to your GENERAL® INTERNATIONAL distributor immediately.
UNPACKING
N - TOOLS
12-14 MM OPEN END WRENCH ...........................................1
8-10 MM OPEN END WRENCH .............................................1
3 MM ALLEN KEY...................................................................1
5 MM ALLEN KEY...................................................................1
8 MM ALLEN KEY...................................................................1
O - HARDWARE
14 MM FLANGE BOLT............................................................3
LARGE LOCK WASHER...........................................................3
LARGE FLAT WASHER .............................................................3
PHILLIPS SCREW .....................................................................4
FLAT WASHER .........................................................................4
SMALL PHILLIPS SCREW .........................................................4
SMALL FLAT WASHER .............................................................4
SMALL PHILLIPS SCREW .........................................................4
SMALL FLAT WASHER .............................................................4
LIST OF CONTENTS
QTY
A - JOINTER BED ........................................................................1
B - FENCE ...................................................................................1
C - PULLEY GUARD .....................................................................1
D - CUTTER HEAD GUARD ASSEMBLY ........................................1
E - BASE......................................................................................1
F - DUST PORT ............................................................................1
G - V-BELT ....................................................................................1
H - PUSH BLOCK.........................................................................2
I - TABLE HEIGHT ADJUSTMENT HANDWHEEL ..........................2
J - FENCE TILT LEVER/HANDLE ..................................................1
K - BASE DOOR..........................................................................1
L - KNIFE SETTING GAUGE (80-125L ONLY)..............................1
M - HELICAL CUTTER HEAD TOOLS/REPLACEMENT PARTS
(80-125LHC ONLY)
5 MM T ALLEN KEY ................................................................1
5 MM ALLEN KEY...................................................................1
NUT.........................................................................................2
SCREW ...................................................................................2
KNIFE-HOLDER/CHIP-BREAKER .............................................1
CARBIDE INSERT (STANDARD) ..............................................2
CARBIDE INSERT (FOR RABBETING)......................................1
A
3X
O
D
G
I
J
4X
4X
4X
4X
4X
C
E
H
N
F
k
L
M
4X
B
3X
3X
9