CONNECTING TO A DUST COLLECTOR
A dust port with a 4” opening is provided to accommo-
date connection to a dust collector (not included).
Once the dust port has been installed, be sure to use
appropriate sized hose and fittings (not included) and
check that all connections are sealed tightly to help min-
imize airborne dust.
If you do not already own a dust collection system
consider contacting your General® International dis-
tributor for information on our complete line of dust
collection systems and accessories or visit our Web Site
at www.general.ca.
RÈGLEDESÉCURITÉ-SAFETYRULES
VCZXZBXCZ
HXCVHJZXVCHVZSJXHVC,
XVCBHJSVDCVWSDV
JHSCHDSDVCVHJ,HSDVB
HBSDHJCVHSDHVCV,
HSVDDVWS
HSDUKCVB.SDV
HJSVCHJVVBNCMXBVJB
BVNMXCB,ZVB,Z
VCZXZBXCZ
HXCVHJZXVCHVZSJX
XVCBHJSVDCVWSDV
JHSCHDSDVCV
HBSDHJCVHSDHVCV,
HSVDDVWS
HSDUKCVB.SDV
HJSVCHJV
BVNMXCB,ZVB,Z
xkcjnvjknckxvnkzx nvcvb
cvjkb ncvbkoidmbp«b
vikmodfidfmofmcmpmpè
dk mfdn oziµonpompmnmcè
kfn ifxcbv invobnoncvknxcklvnzxlcnvklxzècv
ckxvnljkxcbnkvnzxc vbnklzxcnbklcvnklbnclkvnblkzxcn
xcvbjlxzbvlbzdfulbivubidufbfvuibicdcvbuidfbuivbuidbfvuiui
1.
Make sure that the the machine is disconnected from the
power source.
2.
To give yourself unimpeded access to the cutter head
and and upper pulley, remove the cutter head guard
and fence.
3.
Set a straightedge onto the out-feed table so that it
sits over the cutter head but does not completely
cross the gap between the tables and touch the in-
feed table
A
.
4.
Turn the upper pulley by hand, until any one of the
knives is at it’s highest point.
5.
Loosen the out-feed table height adjustment hand
wheel lock knob
B
then loosen the table height
setting locking levers
C
.
6.
Use handwheel
D
to adjust the out-feed table
height so that the knife
barely touches
the straight-
edge.
7.
Re-tighten lock knob
B
and locking levers
C
to secu-
re the out-feed table in position and lock the hand
wheel.
ADJUSTING AND SETTING THE OUT-FEED TABLE HEIGHT
C
B
D
The out-feed table should be set level with the highest point of the knives
A
. The height of the out-feed table should
be verified and adjusted prior to first use. It should also be verified and re-adjusted periodically to compensate for
knife wear and also upon knife replacement.
ALWAYS DISCONNECT THE MACHINE FROM THE
POWER SOURCE BEFORE MAKING ANY ADJUST-
MENTS. FAILURE TO HEED THIS WARNING CAN
LEAD TO SERIOUS PERSONAL INJURY.
A
OUT-FEED
(left)
Table
IN-FEED
(right)
Table
14
Summary of Contents for 80-125L
Page 31: ...31 Notes...