General 80-125L, Setup & Operation Manual

Page: 16 / 32

16
ADJUSTING THE FENCE & CHECKING / SETTING THE FENCE STOPS
1. Using a 90° combination or machinists square, set the
fence to 90°
C .
2. Flip the 90° stop into position D .
3. Loosen the jam nut E on the 90° fence stop bolt.
4. Adjust the 90° fence stop bolt F until it makes contact
with the 90° stop.
5. Retighten the jam nut.
The fence stops allow you to position the fence at specif-
ic pre-set angles in relation to the tables without having to
measure each time you return to that angle.
Due to wear and vibration, fence stops can over time
become misaligned and should be checked periodical-
ly and re-set if necessary.
To set the 90° fence stop:
1. Using a 45° combination or machinists square, set the
fence to 45° inward
J .
2. Loosen the jam nut K .
3. Adjust the 45° inward fence stop bolt L as needed.
4. Retighten the jam nut.
To set the 45° inward fence stop:
C
J
1. Using a combination or machinists square, set the
fence to 45° outward
G .
2. Loosen the jam nut H on the 45° outward fence stop
bolt.
3. Adjust the 45° outward fence stop bolt I until it makes
contact with the back of the fence.
4. Retighten the jam nut.
To set the 45° outward fence stop:
G
I
To move the fence front to back:
1. Loosen locking handle A .
2. Position the fence over the cutter head as needed.
3. Re-tighten locking handle A .
To tilt the fence:
1. Loosen locking handle B .
2. Set the fence 45° inward or 45° inward
3. Re-tighten locking handle B .
A
B
90°
H
L
K
D
F
E