OPERATING INSTRUCTIONS
ALWAYS TURN ON THE DUST COLLECTOR BEFORE STARTING YOUR DUST PRODUCING MACHINE AND ALWAYS STOP THE
DUST PRODUCING MACHINE BEFORE TURNING OFF THE DUST COLLECTOR.
BEFORE STARTING
1.
To minimize airborne dust make sure that all hoses,
fittings and clamps are secure and airtight.
2.
For maximum system efficiency, make sure a cover
is installed on any unused hose inlet openings,
O
.
3.
Never operate the machine without the filter bag or
canister and the collection bag properly installed.
BASIC INSTRUCTIONS
This model 10-105 M1 or 10-105CF M1 Dust Collector has been designed to capture, remove, and collect non-me-
tallic dust and wood dust around the workshop and from woodworking machinery.
THE SOUND LEVEL OF THIS MACHINE IS RATED AT APPROXIMATELY 80-85 DB DURING OPERATION. MAKE SURE THAT ADEQUATE
HEARING PROTECTION IS USED AND THAT THE OVERALL SOUND LEVEL WITHIN THE WORKING ENVIRONMENT IS TAKEN INTO
CONSIDERATION.
Basic assembly is now complete and your dust col-
lector is ready to be put into service. Once the unit is
hooked up to an appropriate electrical connection,
turn on the unit and check for air leaks around the
bags or canister filter
(model 10-105CF M1)
.
If necessary to seal an air leak, peel off the backing
and stick the adhesive foam gasket onto the drum,
making sure the gasket is sitting in the appropriate
groove on the drum,
N
.
STEP 12 - INSTALL FOAM GASKET (IF NEEDED)
If you have model 10-105 M1 with filter bag skip ahead to
step #12.
Fit the canister filter onto the drum as shown in
K
and
use the second belt clamp to secure the canister to the
drum,
L
.
Tip/Hint: To seat the canister on the rim of the drum, run a
flat piece of wood (such as a ruler) between the drum and
the black apron on the bottom of the canister,
M
.
STEP 11 - FIT THE CANISTER FILTER ONTO THE DRUM
– MODEL 10-105CF M1 ONLY
11
K
N
O
L
M
